Fingerprint Firmware Update

From sbv.wiki
Revision as of 17:52, 10 February 2020 by David (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Below is a list of instructions on how to update your fingerprint clock to the latest firmware version.


Updating

  • From the main screen, which displays the date and time, press the arrow that is pointing down in the top right corner of the main screen.

DownloadButton.jpg

  • If you see a yellow bar at the bottom that says "VERIFY YOUR IDENTITY" then a time clock supervisor needs to place their finger.

VerifyYourIdentity.jpg

  • Once verified, you will have two options listed. Click on the first option which is SekureID and then click Run at the bottom of the screen.

SekureIDVersion.jpg

  • Let the clock run the install and once completed, you will see the screen that says "App Upgrade OK". Click LAUNCH APP to go back to the main screen.

SekureIDLaunchApp.jpg

  • Once you click Launch App, the clock will go back to the main screen and you will see the arrow pointing down again. Click it and run the next option which is Timeco.

TimecoVersion.jpg

  • Let the clock run the install and once completed, you will see the screen that says "Module Upgrade OK". Click LAUNCH APP to go back to the main screen.

TimecoLaunchApp.jpg

  • Once you click on LAUNCH APP, the screen will flicker a few times and then go back to the main screen where you will now only see two icons in the top right corner of the main screen. Please also make sure that there are no X's on either of those two icons. If there are, please reboot the clock.