Difference between revisions of "HandPunch Network Configuration Guide"
From sbv.wiki
| Line 1: | Line 1: | ||
| − | == {{# | + | == {{#ireplace:_|<nowiki> </nowiki>|{{#urlget:HandPunch|HandPunch}}}} Configuration == |
| − | + | ||
| − | + | ||
| − | {{# | + | |
| − | + | ||
| − | + | ||
These are the instructions for entering the network information into the HandPunch. | These are the instructions for entering the network information into the HandPunch. | ||
| Line 16: | Line 11: | ||
# Press 2 then Enter. | # Press 2 then Enter. | ||
# Press No (*) until you see '''SET SERIAL'''. Before you press Yes (#) you must be ready to start entering the IP Address on the next step. Press Yes (#). | # Press No (*) until you see '''SET SERIAL'''. Before you press Yes (#) you must be ready to start entering the IP Address on the next step. Press Yes (#). | ||
| − | # Enter ''{{#urlget:IpAddress| | + | # Enter ''{{#ireplace:_|<nowiki> </nowiki>|{{#urlget:IpAddress|192_168_001_099}}}}''. Before you press Yes (#) you must be ready to start entering the Gateway Address on the next step. Press Yes (#). |
| − | # Enter ''{{#urlget:GatewayAddress| | + | # Enter ''{{#ireplace:_|<nowiki> </nowiki>|{{#urlget:GatewayAddress|192_168_001_001}}}}''.. Before you press Yes (#) you must be ready to enter the Host Bits on the next step. Press Yes (#). |
# Enter ''{{#urlget:HostBits|24}}''. Press Yes (#) twice. | # Enter ''{{#urlget:HostBits|24}}''. Press Yes (#) twice. | ||
# Press Clear until you are back to the main screen ('''ENTER ID'''). | # Press Clear until you are back to the main screen ('''ENTER ID'''). | ||
Revision as of 20:14, 30 December 2016
HandPunch Configuration
These are the instructions for entering the network information into the HandPunch.
- From the main screen (ENTER ID), press Clear then Enter.
- If you see ENTER PASSWORD in the display then there are no supervisors currently enrolled in the HandPunch. Skip to step 6.
- You should see a star symbol (*) on the bottom line of the display. If you do not see the * then go back to step 1.
- Enter in your Clock ID and press Enter.
- The displays shows PLACE HAND. Place your hand.
- You will see ENTER PASSWORD in the display.
- Press 2 then Enter.
- Press No (*) until you see SET SERIAL. Before you press Yes (#) you must be ready to start entering the IP Address on the next step. Press Yes (#).
- Enter 192 168 001 099. Before you press Yes (#) you must be ready to start entering the Gateway Address on the next step. Press Yes (#).
- Enter 192 168 001 001.. Before you press Yes (#) you must be ready to enter the Host Bits on the next step. Press Yes (#).
- Enter 24. Press Yes (#) twice.
- Press Clear until you are back to the main screen (ENTER ID).
